Sony XVS-G1

275
Setting a loop
Press the [EFF LOOP] button, turning it on.
When an effect timeline is executed, it repeats executing
in an infinite
loop.
To stop the loop, press the [EF
F LOOP] button, turning it
off. You can also stop by pressing the [REWIND] button.
Executing an Effect Timeline (Menu)
Executing an effect timeline
1 Display the [Effect Timeline Recall/Store] taskbar.
The effect timeline switche
s to recall/store mode.
2 Select a region and recall an effect timeline register.
For details, see “Recalling an Effect Timeline”
(page 264).
3 Press the [Run] button.
The effect timeline is executed.
You can set the operation when
the [Run] button is
pressed again during effect timeline execution.
For details, see “Setting the operation when the
[RUN] button is pressed during effect timeline
execution” (page 416).
Moving to the start point/stop point
1 Display the [Effect Timeline Recall/Store] taskbar.
The effect timeline switche
s to recall/store mode.
2 Select a region and recall an effect timeline register.
For details, see “Recalling an Effect Timeline”
(page 264).
3 Press the [Rewind] button.
When executing in the normal
direction, this moves
to the start point timecode.
When executing in the reverse direc
tion, this moves
to the stop point timecode.
If the start point is set lower than 01:00:00:00,
pressing
the [REWIND] button moves to
01:00:00:00.
Setting the execution direction
1 Display the [Effect Timeline Recall/Store] taskbar.
The effect timeline switches to rec
all/store mode.
2 Select a region and recall an effect timeline register.
For details, see “Recalling an Effect Timeline”
(page 264).
3 Press the [Run Control] button.
The [Run Control] window appears.
4 In the [Direction] group, select an execution
direction.
Normal: Execute
in the normal direction (from the
first keyframe to the last keyframe).
Normal/Reverse: Execution
direction changes each
time the effect timeline execution finishes.
Reverse: Execute
in the reverse direction (from the
last keyframe to the first keyframe).
5 Press [OK].
Setting a loop
1 Display the [Effect Timeline Recall/Store] taskbar.
The effect timeline switches to rec
all/store mode.
2 Select a region and recall an effect timeline register.
For details, see “Recalling an Effect Timeline”
(page 264).
3 Press the [Run Control] button.
The [Run Control] window appears.
4 Set the [Effect Loop] button to the on state.
When an effect timeline is executed, it repeats
exe
cuting in an infinite loop.
To stop the loop, press the [Effect Loop] button,
sett
ing it to the off state. You can also stop by
pressing the [Rewind] button.
5 Press [OK].
Executing an Effect Timeline
(Transition Control Block)
You can operate a recalled effect timeline using the fader
lever in the transition control block/transition control
block (simple type) on the ICP-X7000.
Note
Note