Sony XVS-G1

282
The button color varies as follows, according to the
register state.
Gray characters: Register not c
ontaining a registered
snapshot
White characters: Register containing a registered
snapshot
Lit orange: Last recalled register
You can set the button display for registers with a
regi
stered snapshot to either the register name or register
number. The register number is displayed if a register
name has not been configured.
For details about setting the button display, see “Setting
the button display in snapshot operation mode”
(page 414).
Recalling a Snapshot
Switcher bank region snapshot
1 Press the [SNAPSHOT] button.
The memory recall section switches to snapshot
op
eration mode.
2 Select a bank.
For details about selec
ting a bank, see “Selecting a
bank” (page 281).
3 Select a register to recall a snapshot.
Press the button for the target register.
The register button is lit orange and
the snapshot is
recalled.
To add the auto transition temporary attribute
Press the [AUTO TRANS] button, turning it on
orange,
and press the register button.
To add the effect dissol
ve temporary attribute
Press the [EFF DISS] button, turning it on orange,
an
d press the register button.
In the Flexi Pad control block, it is not possible to add
th
e cross-point hold temporary attribute.
You can use the bus override function and the cross-
po
int button row cross-point hold function.
For details, see “Cross-Point Hold” (page 89).
To undo a register recall
To undo a recall immediately after recalling a register,
press
the [UNDO] button.
Saving a Snapshot
Switcher bank region snapshot
Set the state to save in a snapshot and use the following
procedure to save in a snapshot register.
1 Press the [SNAPSHOT] button.
The memory recall section switches
to snapshot
operation mode.
2 Select a bank.
For details about selecting a bank, see “Selecting a
bank” (page 281).
3 Select a register to save a snapshot.
Press and hold the [SNAPSHOT] button and press the
button
for the target register.
The register button is lit orange and the snapshot is
save
d.
To add the auto transition
attribute
Press and hold the [SNAPSHOT] button and press the
[
AUTO TRANS] button, then continue pressing the
[SNAPSHOT] button and press a register button.
To add the effect dissolve attribute
Press and hold the [SNAPSHOT] button and press the
[EFF DISS] bu
tton, then continue pressing the
[SNAPSHOT] button and press a register button.
For details about setting an attribute, see “Setting an
attribute” (page 288).
If you press a register button
in which a snapshot is
already saved, the register data will be overwritten.
To delete a register
A locked register cannot be deleted.
Press and hold the [DEL] button and press the button for
the
target register to delete.
Note
Note
Note
Note