Sony XVS-G1

289
Editing a Snapshot Register
You can copy, move, and swap register data. You can also
rename, lock, and delete a register.
Copying, moving, and swapping registers between
di
fferent regions is supported between the following
regions.
• Between switcher bank regions (M/E-1 to M/E-5, P/P,
M/E-1 Sub to
M/E-5 Sub, P/P Sub)
• Between DME regions (DME 1 to DME 4)
Copying a register
• An empty register cannot be copied.
• A locked register c
annot be copied.
1 Open the Home > Register > Snapshot > Edit
Register > Copy/Move/Swap menu (18302.13).
A list of copy source registers is
shown on the left,
and a list of copy destination registers is shown on the
right.
2 Press the [Select] button in the [Region] group on the
left.
The [Select Region] window appears.
3 Set the button for the copy source region to the on
state.
Select a tab to change the region to display.
[ME] tab: Switch
er bank regions
[User] tab: User region
s
[DME] tab: D
ME regions
[External Device] tab: E
xternal device regions
4 Press [OK].
5 In the list on the left, select a copy source register.
To select and copy multiple
registers, place a check
mark beside the target registers to copy.
To select and copy all registers, place a check mark in
th
e Select All checkbox.
You can also press the [Select Register(s)] button and
e
nter a register number in the numeric keypad
window.
6 Press the [Select] button in the [Region] group on the
right.
The [Select Region] window appears.
7 Set the button for the copy destination region to the
on state.
Select a tab to change the region to display.
8 Press [OK].
9 In the list on the right, select a copy destination
register.
When multiple registers are selected, select the first
co
py destination register.
You can also press the [Select
Destination] button
and enter a register number in the numeric keypad
window.
The copy destination of the first re
gister selected on
the left is the first register selected on the right, and
the subsequent registers on the right in the same
relative positions as the selected registers on the left
become copy destinations. The first register on the
right is shown in light blue, and the subsequent copy
destination registers are shown in blue gray.
10 Press the [Copy] button.
11 Check the message, then press [OK].
To copy without renaming a destination register
Set the [w/o Name] button to the on
state.
Moving a register
• An empty register cannot be moved.
• A locked register cannot be moved.
Select a move source register and move destination
registe
r in the same way as for copying a register and
press the [Move] button.
For details, see “Copying a register” (page 289).
To move without renaming a
destination register
Set the [w/o Name] button to the on
state.
Swapping registers
Select the registers to swap in the same way as for
copying a register and press the [Swap] button.
For details, see “Copying a register” (page 289).
To swap without renaming the registers
Set the [w/o Name] button to the on
state.
Notes
Notes