Sony XVS-G1

386
• In multi program 2 mode, SL keys are disabled for
PGM2 to PGM4.
• In DSK mode, SL keys are disabled.
• In multi program 2 mode, when [Recall M/E
Config] is
enabled in the Home > Setup > Switcher
> Config > M/E Config menu (19103.12), you can
also change the keys to enable in the Common >
Key Priority/Key Assign menu of the switcher
bank.
For details, see “To change program output key
assignments” (page 239).
6 Press [OK].
Setting the key preview output
You can select the key preview output mode (video mode
or key mode) and the background/key to display.
Key preview does not support SL keys.
1 Open the Home > Setup > Switcher > Config > K-
PVW Config menu (19103.14).
2 Select the target key preview output to set.
3 Press the [Mode] button and select a key preview
mode from the pull-down list.
Video: Vide
o mode (key + background)
Key: Key mo
de (key only)
When [Key] is selected, proc
eed to step 5.
4 Press the [Background] button and select a
background from the pull-down list.
You can select the following backgrounds.
Standard mode: Clean
Multi program mode: Clean, Utility2
Multi program 2 mode: Clean, Sub Clean
DSK mode: DSK Background 1 to 4
5 Press the [Edit] button for [Key Preview Config].
The [Key Preview Config
] window appears.
6 Press the button for the target key and select a display
mode from the pull-down list.
Link: Key disp
lay/non-display is linked to key on/
off.
On: Displ
ay key.
Off: Do
not display key.
The key preview 1 setting is li
nked to the following
utility commands.
• M/Ex Key1 PVW to M/Ex Key8 PVW (x = 1 to 5)
• P/P Key1 PVW to P/P Key8 PVW
Executing key preview output using a utility
co
mmand sets the target key to [On] and sets all other
keys to [Off].
For example, executing key preview output for key 1
o
nly using a utility command sets key 1 to [On] and
key 2 to key 8 to [Off] in the key preview 1 settings.
7 Press [OK].
Setting a DSK mode background
In DSK mode, you can select a switcher bank output to
assign to a background (DSK Background 1 to 4).
1 Open the Home > Setup > Switcher > Config > DSK
Bkgd Assign menu (19103.15).
2 Select the target background to set.
3 Press the [Edit] button for [Assigned M/E Output].
The [M/E Output Assign] window appears.
4 Set the button for the target output to the on state.
5 Press [OK].
Setting the recall target for an effect
timeline/snapshot
When an effect timeline or snapshot is saved or recalled,
the settings data of the following menus becomes the
target.
• Home > Setup > Switcher > Config > M/E Config menu
(1
9103.12)
• Home > Setup > Switcher > Config > PGM Config
men
u (19103.13)
• Home > Setup > Switcher > Config >
K-PVW Config
menu (19103.14)
The settings are common to all switcher banks.
1 Open the Home > Setup > Switcher > Config > M/E
Config menu (19103.12).
2 Set the [Recall M/E Config] button to the on state.
Note
Note