STARLITE Mk5 User Manual Version 1.2
56
Basic Tools and Test Equipment Required
The Starlite Mk 5 is designed to require the minimum of tools for general use and normal routine
maintenance. Most of the tools listed below should be readily available in any technician’s toolbox,
but please note the following points;
• All fasteners used in the Starlite Mk 5 are of the standard METRIC type, apart from the exception
of the lamp isolating posts which are UNC 8-32 x ¼”.
• Some of the fasteners in the unit are tightened up to a specific tightness or “torque”.
The alteration of these fasteners is not recommended and therefore is not covered in this
manual. Failure to observe this warning may lead to serious damage of the unit and a
potential safety hazard and invalidate the warranty!
• Always use the correct size of screwdriver, socket or Hex driver for the fastener in question.
DO NOT USE the closest “equivalent”!
• When necessary, always replace a fastener with the correct type.
e.g. M3 x12 (i.e. thread diameter x thread length.)
Tools
Set of long reach hex keys or ”Allen keys” (inc. 1.5mm AF to 6mm AF)
Set of flat bladed screwdrivers
Set of hex sockets (inc. 5mm, 5.5mm, 7mm, 8mm AF)
Pair of small “long-nosed” pliers
“Pre-set” trimming tool or small flat bladed screwdriver
Test Meter
Reasonably good quality multimeter (preferably digital) with Ohms, AC/DC Volts and continuity
ranges.
To Next Page
Loading...