Starlite MK5 - Page 6

STARLITE Mk5 User Manual Version 1.2
6
Max. Required DMX Channels:__________________________________________________ 21
FACTORY SET PERSONALITY _______________________________________________________ 22
DEFAULT CHANNEL CONFIGURATION (“PERSONALITY”)__________________________________ 22
UNIT REVIEW ___________________________________________________________________ 26
Base of the unit_______________________________________________________________ 26
Connector Panel______________________________________________________________ 26
Status Indicator Panel _________________________________________________________ 26
SET THE STARLITE MK5 UNIT VOLTAGE _____________________________________________ 27
DC Supply (Motors & Electronics) Voltage Selection_________________________________ 27
To change the selector switch:___________________________________________________ 27
Lamp Ballast Voltage/Frequency Selection_________________________________________ 28
Magnetic Ballast Version_______________________________________________________ 28
Electronic Ballast Version ______________________________________________________ 28
The Yoke ____________________________________________________________________ 29
The Head ___________________________________________________________________ 29
“Fan” Side of the Head (Earlier models) __________________________________________ 29
“Fan” Side of the Head (Current models)__________________________________________ 30
OPEN VIEW OF THE HEAD (FAN SIDE)_________________________________________________ 31
“Motherboard” Side of the Head ________________________________________________ 32
Lamp Housing________________________________________________________________ 33
TO INSTALL OR REPLACE THE LAMP __________________________________________________ 33
Lamp Installation (cont.) _______________________________________________________ 34
SETTING THE DMX START ADDRESS BCD SWITCHES ___________________________________ 35
Self Test Mode _______________________________________________________________ 35
SETTING THE DRIVE CARD DIP SWITCHES ____________________________________________ 36
Drive Card DIP Switches _______________________________________________________ 36
Drive Card Address Information _________________________________________________ 37
Function Address _____________________________________________________________ 37
DMX Address ________________________________________________________________ 37
Drive card motherboard positions ________________________________________________ 38
UNIT REVIEW (CONT.) ____________________________________________________________ 39
Front (Indicator) Side of the Base ________________________________________________ 39
2 Way Switch ________________________________________________________________ 39
Status LED’s_________________________________________________________________ 40
Rear (DC Supply) Side of Base __________________________________________________ 41
Lamp PSU Side of the Base _____________________________________________________ 41
SERVICING THE STARLITE MK5________________________________________________ 42
GENERAL MAINTENANCE AND CLEANING _____________________________________________ 42
Cleaning the external surfaces___________________________________________________ 42
REMOVING AND CLEANING THE INTERNAL HEAD COMPONENTS ____________________________ 42
Removing Head Modules _______________________________________________________ 42
Removing the Focus Module ____________________________________________________ 42
Removing the Motherboard _____________________________________________________ 42
Removing the CMY Module _____________________________________________________ 43
Removing the Prism Module ____________________________________________________ 43
Removing the Gobo Module_____________________________________________________ 44
CLEANING HEAD MODULES________________________________________________________ 45
Cleaning Rotating gobos _______________________________________________________ 45
Cleaning Cross Fade Colours ___________________________________________________ 45
Cleaning the Triplet Lens_______________________________________________________ 45
Cleaning the Prism Module _____________________________________________________ 45
REPLACING PARTS _______________________________________________________________ 46
Remove and Install Rotating gobos _______________________________________________ 46
Remove and replace colour wheel Dichroic Filters __________________________________ 46
Remove and install gobos in the optional Static Wheel. _______________________________ 47
STARLITE MK5 ADJUSTMENTS _____________________________________________________ 48
Adjusting the Decoder card reference voltage. ______________________________________ 48