Starting up SN910 models
Plug your SN Firewall into the mains power supply, it will automatically start up. Ensure that the
power supply switch is "ON". Your Firewall will then start running automatically, the Power LED will
light up. Then wait several minutes.
NOTE
When you hear 8 consecutive beeps, you will be able to insert a USB key containing a
configuration if necessary. Console mode will display the following message: “Please insert
your USB token to continue”.
Two consecutive beeps indicate the end of the product’s startup sequence.
Starting up SN2100 and SN3100 models
As soon as the appliance is powered up, press once on the
Power button (rear panel). Wait a few minutes for all 3 LEDs –
Online, Status and Power to light up.
NOTE
When you hear 8 consecutive beeps, you will be able
to insert a USB key containing a configuration if
necessary. Console mode will display the following
message: “Please insert your USB token to continue”.
Two consecutive beeps and the lighted up Online LED indicate
the end of the product’s startup sequence.
Starting up SN6100 models
As soon as the appliance is powered up, press once on
the Power button (rear panel). Wait a few minutes for
both LEDs – Power and Run to light up.
NOTE
When you hear 8 consecutive beeps, you will be
able to insert a USB key containing a
configuration if necessary. Console mode will
display the following message: “Please insert
your USB token to continue”.
Two consecutive beeps indicate the end of the product’s
startup sequence.
SNS - PRODUCT PRESENTATION AND INSTALLATION 2019
INITIAL CONNECTION TO THE PRODUCT
Page 48/66 sns-en-SNrange_installation_guide-2019 - 09/2019
To Next Page
Loading...
