IKE Policy
This screen allows you to configure IKE policy for auto negotiating IPsec Security
Associations over IPv6.
IKE Phase 1 Policies: This section may be used to create, delete, and modify ISAKMP (IKE
phase 1) policies. Phase 1 is used to securely authenticate peers.
• Address: The address of the peer the policy will apply to. A policy for “anonymous” will apply to
all peers without a more specific policy.
• Preferred Exchange Mode: The preferred exchange mode is the one that will be sent in any
proposal to a peer. If other exchange modes are specified, they will be accepted in received
proposals. With Aggressive, the DH Group in the sent proposal must exactly match the peer’s
configuration.
Warning: Misconfiguration on this screen may block network access to the Switch’s configuration
interface.
4-57
Chapter 4 - Managed Switch Software Setup
Stride Industrial Ethernet Switches User Manual 2nd Ed. Rev. A
To Next Page
Loading...