Stride Industrial Ethernet Switches User Manual 2nd Ed. Rev. B
Chapter 2 - Managed Switch Quick Start
Default Setup
The table below shows the Default settings for the switch:
Stride Managed Switch Default Settings
Configuration Parameter Default Setting
Main Settings
System Settings
DHCP
Disabled
IP Address
192.168.0.1
Subnet Mask
255.255.255.0
Default Gateway
none
Primary DNS Server
none
Secondary DNS Server
none
Domain
Redundancy Protocol
Rapid Spanning Tree Protocol
System Name
Switch model (i.e. SE-SW8MG-4P)
Switch Location
<Set Location of Switch>
Contact
<Set Name (and email) of contact for Switch>
Remote Access Security
SNMP Access
Basic and secure SNMP access
Terminal Access
SSH and telnet access
Web Access
Basic and secute SNMP access
SNMP Firmware Loading
Disabled
Command Line Access
Enabled
Automatic Logout
Disabled
SNMP Read-Only
Name: public No Password
SNMP Read/Write
Name: private No Password
Terminal and Web
Name: admin Password: admin
Port Settings
Name
port x (x being port number)
Admin
Enabled
Negotiation
Auto
Speed/Duplex
For non Gigabit Switches: 10h,10f,100h,100f all on
For Gigabit Switches: 10h,10f,100h,100f,1000f all on
Flow Control
Off
SFP
1000f selected
Set IP per Port
Provide/Do Not Provide IP
Do not provide IP address to any device
Enabled
Off for all ports
Address
blank for all ports
Switch Time Settings
NTP Server
none
Timezone
Not set
Set Switch Date
1970-01-01
Set Switch Time
current time
Manage Firmware Default
Top line selected
Install Firmware
Protocol
HTTP
All Other Fields
blank
2-13
To Next Page
Loading...