STRIDE SE-SW5U - IGMP Configuration; Checkpoint Configuration; Firmware Configuration; TFTP Configuration

Stride Industrial Ethernet Switches User Manual 2nd Ed. Rev. B
Appendix D - CLI Commands
IGMP Configuration:
IGMP Configuration
Parameter Default Allowable Values / Description
rlist
n/a No value / Lists router settings for all ports
mode
disabled disabled, snoop, router / view or change IGMP mode
msupp
none none, ip, all / view or change the multicast suppression method
version
2 1, 2 / IGMP version
robustness
2 1 - 99 / IGMP robustness
ginterval
125 60 - 125 / IGMP query interval
gresponse
10 1 - 30 / IGMP query response interval
The commands below require a port #
router
0 0, 1 / identify ports which lead to IGMP routers
exclude
0 0, 1 / Exclude a port from the processing of IGMP requests and queries
Checkpoint Configuration:
Checkpoint Configuration
Parameter Default Allowable Values / Description
save
n/a None / saves a check point
restore
n/a net, nonet / net saves current network settings, nonet discards them
ftpsave
n/a a file name
ftprestore
n/a a file name
Firmware Configuration:
Firmware Configuration
Parameter Default Allowable Values / Description
default
n/a 1 or 2 / View or change the default firmware
running
n/a View which firmware image is running
list
n/a
View list of currently available firmware images and corresponding health
status
update
n/a
Followed by [showProgress] [md5=<md5>] <url>
If the ‘showProgress’ argument is provided, progress printouts will be
displayed.
If the ‘md5’ argument is provided, the MD5 checksum of the received
firmware will be tested against the provided MD5 checksum.
The URL must be a valid HTTP or HTTPS address to which the Switch
has direct access.
ftpload
n/a Followed by the filename to be uploaded from the TFTP server
TFTP Configuration:
TFTP Configuration
Parameter Default Allowable Values / Description
tftp
“ “ A valid fully-qualified domain name
D-9