STRIDE SE-SW5U - Network Configuration

Stride Industrial Ethernet Switches User Manual 2nd Ed. Rev. B
Appendix D - CLI Commands
Network Configuration:
The switch can have DHCP enabled or disabled. When it is enabled, settings for IP address,
subnet mask, and default gateway may still be set. The values will be stored and used should
DHCP be disabled in the future.
Info Configuration
Parameter Default Allowable Values / Description
fwversion
n/a View the current firmware version
cfgversion
n/a View the configuration version number
macaddr
n/a View the MAC address of the Switch
link
n/a ‘all’, port# / show specified port (s) link status
support
n/a displays useful support information (IP, etc.)
These settings require a filter to be specified:
info <parameter> <filter> [<value>]
Port Security Configuration:
Port Security Configuration
Parameter Default Allowable Values / Description
list
n/a List all current port security information
enable
n/a Enables MAC-based port security
disable
n/a Disables MAC-based port security
add
n/a
Any valid MAC and port number / allow communication by the specified
MAC on the specified port.
remove
n/a Any valid MAC / remove a MAC address from the security table
Port Configuration:
Port Configuration
Parameter Default Allowable Values / Description
list
n/a No value, lists all settings for all ports
monitor
1 Any port number
These settings require a port number, usage:
port <port #> <parameter> [<new value>]
name
port_# A string
admin
enabled enabled, disabled
negotiation
enabled enabled (auto-negotiation), disabled (fixed negotiation)
ratelimit
enabled enabled, disabled
direction
none none, egress, both
giveip
disabled enabled, disabled
ipaddr
none An IP address
Sfp
1000 100, 1000
speed
(see below) (see below)
With auto negotiation, <speed> may be:
10H, 10F, 100H, 100F, 1000F or FC
With fixed negotiation, <speed> may be:
100H or 100F
D-5