1-10
Stride Industrial Ethernet Switches User Manual 2nd Ed. Rev. B
Chapter 1 - Hardware
ACT/LNK LED
This is the Yellow LED on models with two LEDs per RJ45 port.
Speed 10/100 LED
This is the Green LED on models with two LED’s per RJ45 port.
ACT/LNK/Speed LED
This is a bi-color (Green / Yellow) LED on models with one LED per RJ45 port.
ON Solid (not flashing)
Indicates that there is a proper Ethernet connection (Link) between the port and another
Ethernet device, but no communications activity is detected.
Flashing
Indicates that there is a proper Ethernet connection (Link) between the port and another
Ethernet device, and that there is communications activity.
Green
On 10/100 ports, a 100 Mbps connection is detected.
On 10/100/1000 ports, a 1000 Mbps connection is detected.
Yellow
On 10/100 ports, a 10 Mbps connection is detected.
On 10/100/1000 ports, a 10 or 100 Mbps connection is detected.
OFF
Indicates that there is not a proper Ethernet connection (Link) between the port and
another Ethernet device. Make sure the cable has been plugged securely into the ports
at both ends.
OK LED
Managed Models: This LED indicates the status of the power inputs. There is an output
screw terminal that can be connected as shown in the wiring diagram. The output voltage
between the screw terminal marked ‘OK’ and the terminal marked ‘–’ will be the same as
the applied switch input voltage. The output will be ON when both the PI and P2 terminals
have power applied to them. It will be OFF if either input does not have power or the switch
software is not running.
ON (yellow)
(not flashing)
Indicates that there is a proper Ethernet connection (Link) between the port and another
Ethernet device, but no communications activity is detected.
ON (yellow)
(flashing)
Indicates that there is a proper Ethernet connection (Link) between the port and another
Ethernet device, and that there is communications activity.
OFF
Indicates that there is not a proper Ethernet connection (Link) between the port and
another Ethernet device. Make sure the cable has been plugged securely into the ports
at both ends.
ON (green)
A 100 Mbps (100BaseT) connection is detected.
OFF
A 10 Mbps (10BaseT) connection is detected.
To Next Page
Loading...