www.stryker.com 6086-009-001 REV B 23
Return To Table of Contents
Adjusting Cot Load Height
Before placing the cot into service, confirm that the cot load height is set correctly for your vehicle. The cot load height
can be adjusted to match the height of the vehicle deck. If the cot does not line up correctly, adjustments may need
to be made to the cot load height.
WARNING
Before placing the cot into service, confirm that the cot load height is set correctly for your vehicle.
To check the load height of the Performance-PRO™ XT cot:
1. Roll the cot up to the loading area of your vehicle.
2. Compare the difference between the deck height of the
vehicle and the load height of the cot.
3. Select HIGH, MID or LOW depending on the cot load
height requirements (see Figure 12). For example:
• The HIGH marking on the rack is recommended for
vehicle deck heights above 32 inches.
• The MID marking on the rack is recommended for
vehicle deck heights between 30 and 32 inches.
• The LOW marking on the rack is recommended for
vehicle deck heights below 30 inches.
4. Verify that the safety hook always engages the cot safety
bar, regardless of how the cot is unloaded from the
vehicle. If the safety bar misses the safety hook, select
the next lower height setting.
For deck heights above 32”
For deck heights between 30-32”
For deck heights below 30”
Figure 12: Cot Load Height
To Next Page
Loading...
