Stryker Performance-PRO XT User Manual

www.stryker.com 6086-009-001 REV B 51
Return To Table of Contents
Optional Accessories
USING THE RETRACTABLE HEAD SECTION OXYGEN BOTTLE HOLDER
To attach an oxygen bottle to the retractable head section oxygen bottle holder:
1. Center the oxygen bottle on the cradled surface of item (A) as shown in Figure 54.
2. Tighten both straps (B) around the oxygen bottle.
3. Secure the slack on the straps to the Velcro
®
on the straps.
Note: Inspect the straps and clips for wear between use and replace the strap if it is no longer holding the oxygen
bottle.
WARNING
If the cot is equipped with the optional retractable head section oxygen bottle holder, use caution while the oxygen bottle
holder is installed to avoid pinching your fingers between the fowler bracket and the oxygen bottle.
CAUTION
• To avoid damage to the oxygen bottle holder (if equipped), the weight of the equipment must not exceed 40 lb (18
kg).
• Do not use two head end oxygen bottle holders at the same time.
Figure 54: Retractable Head Section Oxygen Bottle Holder
A
B

Stryker Performance-PRO XT Specifications

General

Brand	Stryker
Model	Performance-PRO XT
Category	Medical Equipment
Language	English