www.stryker.com 6086-009-001 REV B 17
Return To Table of Contents
Note: The Cot Fastener Installation instructions on page 17 through page 22 are intended for cots that you will
NOT use with Power-LOAD. For Model 6086 cots with the Power-LOAD option, see the Power-LOAD Operations/
Maintenance Manual for installation instructions.
The Stryker Cot Fastener Systems are designed to be compatible only with cots which conform to the installation
specifications listed on page 18.
WARNING
It is the responsibility of the cot operator to ensure that the cot being used in the Stryker Cot Fastener Systems meets the
installation specifications listed on page 18. Injury may result if a non-compatible cot is used in the Stryker Fastener
System.
Note: Adjustment of the rail clamp assembly may be required in order to compensate for any variation in the cot
retaining post position depending on the cot manufacturer and model number.
For more information about the Stryker Cot Fastener Systems, see the Cot Fastener Operations/Maintenance Manual.
Cot Fastener Installation
To Next Page
Loading...
Need help?
General
