www.stryker.com 6086-009-001 REV B 33
Return To Table of Contents
Operation Guide
UNLOADING AN EMPTY COT FROM A VEHICLE WITH ONE OPERATOR
WARNING
• The one person loading and unloading procedures
are for use only with an empty cot. Do not use the
procedures when loading or unloading a patient. Injury
to the patient or operator could result.
• Do not pull or lift on the safety bar when unloading the
cot. Damage to the safety bar could result and injury
to the patient or operator could occur.
• Ensure proper hand placement on hand grips. Hands
should be clear of red safety bar pivots while loading
and unloading the cot or whenever changing height
position of the cot with two or more operators.
To unload an empty cot from a vehicle with one
operator:
1. Lift the vehicle bumper to the raised position (if
equipped).
2. Disengage the cot from the cot fastener. (For more
information about the cot fastener, see page 17).
Grasp the cot frame at the foot end; pull the cot from
the vehicle until the safety bar engages the safety hook
(see Figure 26).
3. Lower the foot end of the cot to the ground (see Figure
27).
4. Squeeze and hold the release handle (see Figure 28)
and raise the foot end of the cot back to a level position
with the compartment floor.
5. Disengage the safety bar from the safety hook by
pushing the safety bar release lever forward and roll
the cot out of the vehicle.
Figure 28: Squeeze the Release Handle
Figure 26: Pull the Base of the Cot
Figure 27: Lower the Foot End of the Cot
To Next Page
Loading...
Need help?
General
