56 6086-009-001 REV B www.stryker.com
Return To Table of Contents
Cleaning
The Performance-PRO™ XT cot is designed to be power washable. The unit may show some signs of oxidation or
discoloration from continuous washing, however, no degradation of the cot’s performance characteristics or functionality
will occur due to power washing as long as the proper procedures are followed.
Thoroughly clean the cot once a month. Clean Velcro
®
AFTER EACH USE. Saturate Velcro
®
with disinfectant and allow
disinfectant to evaporate. Appropriate disinfectant for nylon Velcro
®
should be determined by the service.
WASHING PROCEDURE
• Followthecleaningsolutionmanufacturer’sdilutionrecommendationsexactly.
• The preferred method Stryker Medical recommends for power washing the cot is with the standard hospital
surgical cart washer or hand held wand unit.
WASHING LIMITATIONS
WARNING
When cleaning, use any appropriate personal safety equipment (goggles, respirator, etc.) to avoid the risk of inhaling
contagion. Use of power washing equipment can aerate contamination collected during the use of the cot.
CAUTION
• DO NOT STEAM CLEAN OR ULTRASONICALLY CLEAN THE UNIT.
• Maximum water temperature should not exceed 180°F/82°C.
• Maximum water pressure should not exceed 1500 psi/130.5 bar. If a hand held wand is being used to wash the
unit, the pressure nozzle must be kept a minimum of 24 inches (61 cm) from the unit.
• Allow cot to air dry.
• Towel dry all casters and interface points.
• Failure to comply with these instructions may invalidate any/all warranties.
To Next Page
Loading...
Need help?
General
