Studer Innotec SA
next3
Technical user manual V1.3 © Studer-Innotec SA 17
9.
Fix the structure at the bottom with the provided screw
10.
Fix the belt on the sides with the screws provided
11.
Fix the nx interface with 2 screws provided. Install the communication cable on the
screen before mounting.
The nx-communication cable goes in the plug on the left of the nx interface and is easier to
install before the mounting on the nx device. The ethernet cable (LAN) goes on the right.
See the wiring sections for details.
Special installation on the wall or in a cabinet is shown in the following chapter below.
12.
Open the bottom panel and proceed to wiring.
To Next Page
Loading...