Studer NEXT3 - Page 18

Studer Innotec SA
next3
18 V 1.3 © Studer-Innotec SA next3 Tech manual
Go to the wiring section of this manual for all explanations about electrical connexions.
4.4.2.1 Nx-interface wall mounting
The nx-interface can be hanged on a wall with two screws. The head of the screw goes in the
dedicated slot on the back of the nx-interface.
AC-Source
L1-L2-L3-N
AC-Flex
L1-L2-L3-N
AC-Loads
L1-L2-L3-N
BAT-
BAT+
AC PE earth
connection
Button
battery for
clock (RTC)
Use suitable screws
and buffers.
The maximum
diameter
of the screws is 8mm.
Maintain a space of
3mm between the
screw head and the
wall.