Studer Innotec SA
next3
90 V 1.3 © Studer-Innotec SA next3 Tech manual
If the battery cycling is wanted (charge-discharge frequently), the SOC for backup
will be set to 30%. If not, it will be adjusted to 100%.
• If your next3 is connected to internet and to the Studer web portal (www.portal.studer-
innotec.com) you must make the pairing with your account. This is done with the unique
number called GUID. Copy exactly this number on both side for pairing. A GUID can be
generated by the nx-interface, or by the web portal, or you can do the pairing with the serial
number of the device (Option automatically get new GUID from Webportal).
(not available in first release!)
This GUID must be copied on the webportal in the GUID field when creating a new
installation:
• Final check: a summary of the installation is given and the configuration process is finished.
Press “Start using the system!”
After the first configuration with the wizard, the next3 is ready to be used.
To Next Page
Loading...
Need help?
General