Sun Microsystems SPARCstation 10SX User Manual

Chapter 11 System Board and Component Replacement 167
FIGURE 11-31 Inserting a DSIMM
FIGURE 11-32 Inserting a VSIMM/NVSIMM
9. Put the heel of each hand on each side of the insertion tool pushing surface. Press
firmly with both hands on the tool until the SIMM snaps into place.
Note – When installing a VSIMM in slot J0305, an AVB must also install. See
“Auxiliary Video Board” on page 168.
10. Remove the insertion tool.
Insertion tool
Grooved surface
Grooved surface
Insertion tool

Sun Microsystems SPARCstation 10SX Specifications

General

Brand	Sun Microsystems
Model	SPARCstation 10SX
Category	Desktop
Language	English