Sun Microsystems SPARCstation 10SX User Manual

Chapter 8 Removing and Installing Subassemblies 59
FIGURE 8-3 Power Supply Captive Screws
5. Connect the DC power connector to the system board (FIGURE 8-4).
6. Remove the wrist strap and replace the cover.
See Chapter 7.
7. Connect the power cord to the rear of the system unit and the wall receptacle.
8. Power on the system.
See “Turning On the Power” on page 47.
FIGURE 8-4 Connecting the DC Power Connector to the System Board
Captive
screw (2)
DC power
Power
connector
supply
System board

Sun Microsystems SPARCstation 10SX Specifications

General

Brand	Sun Microsystems
Model	SPARCstation 10SX
Category	Desktop
Language	English