Appendix E Selected On-Board Diagnostics 227
CODE EXAMPLE E-7 identifies the probe-scsi command output message.
CODE EXAMPLE E-8 identifies the probe-scsi-all command output message.:
test-memory
The test-memory command tests the main memory if the system diag-switch?
parameter is set to true. If the system diag-switch? parameter is set to false, the
test-memory command verifies the memory according to a user-specified number
of megabytes to be examined.
When the test-memory command is active, the quantity of memory being tested is
displayed in megabytes and sequentially decrements to zero during the test. If the
diag-switch? parameter is set to false, the test-memory command uses
theselftest-#megs parameter in NVRAM to determine the quantity of memory to
test. The default setting for the selftest-#megs parameter is 1, thus testing one
megabyte of memory. To change the amount of memory to test, use the selftest-
#megs parameter and enter the example command where XX is any whole number
that does not exceed the actual size of memory in megabytes.
CODE EXAMPLE E-7 probe-scsi Command Output Message
ok probe-scsi
Target 3
Unit 0 Disk SEAGATE ST1480 SUN04245828 Copyright (c) 1991
Seagate All rights reserved.
CODE EXAMPLE E-8 probe-scsi-all Command Output Message
ok probe-scsi-all
/iommu@f,e0000000/sbus@f,e0001000/dma@1,81000/esp@1,80000
Target 2
Unit 0 Disk SEAGATE ST41600N SUN1.3G00286965 Copyright (c)1991
Seagate All rights reserved.
/iommu@f,e0000000/sbus@f,e0001000/espdma@f,400000/esp@f,800000
Target 3
Unit 0 Disk SEAGATE ST1480 SUN04245828 Copyright (c)1991 Seagate
All rights reserved.
To Next Page
Loading...
Need help?
General
