SunFounder ESP32 Starter Kit
Note: The initial compilation will download dependency packages, which might take around 10
minutes. Please be patient. If the process stalls for a long time, check if there’s enough disk space on
your system.
15. Wait for the INFO Successfully compiled program. message, indicating firmware compilation is com-
plete.
Note: At this point, you should see the node as ONLINE. If not, ensure your ESP32 is on the same
network segment or try rebooting the device.
2. Configuration in Home Assistant
After integrating with Esphome, you still need to configure the camera in homeassistant.
1. Go to Settings > Devices & Services.
216 Chapter 1. For Arduino User
To Next Page
Loading...