SunFounder ESP32 Starter Kit
1.16 4.3 Swinging Servo
A Servo is a type of position-based device known for its ability to maintain specific angles and deliver precise rotation.
This makes it highly desirable for control systems that demand consistent angle adjustments. It’s not surprising that
Servos have found extensive use in high-end remote-controlled toys, from airplane models to submarine replicas and
sophisticated remote-controlled robots.
In this intriguing adventure, we’ll challenge ourselves to manipulate the Servo in a unique way - by making it sway!
This project offers a brilliant opportunity to dive deeper into the dynamics of Servos, sharpening your skills in precise
control systems and offering a deeper understanding of their operation.
Are you ready to make the Servo dance to your tunes? Let’s embark on this exciting journey!
Required Components
In this project, we need the following components.
It’s definitely convenient to buy a whole kit, here’s the link:
Name ITEMS IN THIS KIT LINK
ESP32 Starter Kit 320+
You can also buy them separately from the links below.
COMPONENT INTRODUCTION PURCHASE LINK
ESP32 WROOM 32E
ESP32 Camera Extension -
Jumper Wires
Servo
Available Pins
Here is a list of available pins on the ESP32 board for this project.
Available Pins IO13, IO12, IO14, IO27, IO26, IO25, IO33, IO32, IO15, IO2, IO0, IO4, IO5, IO18, IO19,
IO21, IO22, IO23
Schematic
58 Chapter 1. For Arduino User
To Next Page
Loading...
Need help?
General