SunFounder ESP32 Starter Kit
1.51 8.8 Camera with Home Assistant
This project will guide you in setting up a video stream web server for the ESP32 camera and integrating it with the
popular home automation platform, Home Assistant. This integration will allow you to access the server from any
device on your network.
Note: Before diving into this project, you need to have an operating system with Home Assistant installed.
We recommend installing the Home Assistant OS on a Raspberry Pi.
If you don’t have a Raspberry Pi, you can also install it on a virtual machine running on Windows, macOS, or Linux.
For installation instructions, refer to the official website link: https://www.home-assistant.io/installation/
Please proceed with this project only after successful installation.
Required Components
In this project, we need the following components.
It’s definitely convenient to buy a whole kit, here’s the link:
Name ITEMS IN THIS KIT LINK
ESP32 Starter Kit 320+
You can also buy them separately from the links below.
COMPONENT INTRODUCTION PURCHASE LINK
ESP32 WROOM 32E
ESP32 Camera Extension -
1. Configuration in ESP Home
1. First plug in the camera.
2. Connect your ESP32 to the host where you’ve installed the Home Assistant system (e.g., if installed on a Rasp-
berry Pi, connect to the Pi).
1.51. 8.8 Camera with Home Assistant 207
To Next Page
Loading...
Need help?
General