SunFounder ESP32 Starter Kit
1.52 8.9 Blynk-based Intrusion Notification System
This project demonstrate a simple home intrusion detection system using a PIR motion sensor (HC-SR501). When the
system is set to “Away” mode through the Blynk app, the PIR sensor monitors for motion. Any detected movement
triggers a notification on the Blynk app, alerting the user of potential intrusion.
Required Components
In this project, we need the following components.
It’s definitely convenient to buy a whole kit, here’s the link:
Name ITEMS IN THIS KIT LINK
ESP32 Starter Kit 320+
You can also buy them separately from the links below.
COMPONENT INTRODUCTION PURCHASE LINK
ESP32 WROOM 32E
ESP32 Camera Extension -
Jumper Wires
PIR Motion Sensor Module
1.52. 8.9 Blynk-based Intrusion Notification System 221
To Next Page
Loading...