SunFounder ESP32 Starter Kit
4.11.1 Required Components
In this project, we need the following components.
It’s definitely convenient to buy a whole kit, here’s the link:
Name ITEMS IN THIS KIT LINK
ESP32 Starter Kit 320+
You can also buy them separately from the links below.
COMPONENT INTRODUCTION PURCHASE LINK
ESP32 WROOM 32E
ESP32 Camera Extension -
Breadboard
Jumper Wires
DHT11 Humiture Sensor
4.11.2 You Will Learn
• Get the temperature and humidity from the DHT11 module
• Serial Monitor for Upload Mode
• Add extension
4.11.3 Build the Circuit
The digital temperature and humidity sensor DHT11 is a composite sensor that contains a calibrated digital signal
output of temperature and humidity.
Now build the circuit according to the following diagram.
4.11. 2.8 Read Temperature and Humidity 521
To Next Page
Loading...
Need help?
General