39
5.5 Installing the Inverter
Install the inverter on the wall using the provided wall-mounting bracket and expansion plug
sets.
The expansion plug set shown below is recommended for the installation.
(1) Self-tapping
screw
(2) Expansion tube (3) Fender washer (4) Spring washer
step 1 Install the wall-mounting bracket.
Note:
1 The depth of the holes should be about 70 mm.
2 The bubble in the bubble level on the mounting-bracket must be centered to ensure that
the device will be placed horizontally.
step 2 Mount the inverter to the bracket. Secure the inverter with two M4 screws and washers. (1.5
N•m)
User Manual 5 Mechanical Mounting
To Next Page
Loading...
