SWL Series Skid Steer Loader
13
• Before enter and leave the machine, make sure the footplate and handles are not covered
with oil, grease, ice or other slippery matter. In case it
happens, clean the slippery matter carefully
immediately.
• Take great care in case the machine is wet. It could be
very slippery.
Before leave machine, carry out the following procedures
in the sequence.
1) Park the machine in a safe position.
2) Lower the working equipment to the ground.
3) Engage the parking brake.
4) Engage the auxiliary equipment control pedal retainer.
5) Raise the restrain bar to upward.
6) Stop the engine.
2.3.4 PREVENTION OF FIRE TO FUEL AND OIL
• Fuel and oil are easily to cause fire if they meet flame.
• Keep always flame away from the fuel and oil.
• Stop the engine and never smoke during refueling.
• Only do the refilling fuel and oil in the well ventilated areas.
• Close well the safety cap after refilling oil or fuel.
• Do not fill the tanks in order to leave room for the fuel expansion.
• If some fuel or oil is spilled wipe it up immediately.
2.3.5 PREVENTION OF BURNS
• After operating for a period, the engine, coolant,
hydraulic oil, engine oil, radiator and pumps are hot.
Do not touch them until they cool down.
• In case of entailing working with hot oil, hot coolant
or hot hydraulic oil, wear gloves, heavy clothing and
safety goggles before do any check or maintenance.
To Next Page
Loading...
