EasyManua.ls Logo

SUNWARD SWL3210 - Moving on Slopes; Moving on Unusual Surfaces; Parking the Machine

SUNWARD SWL3210
89 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SWL Series Skid Steer Loader
16
2.4.3.1 MOVING ON SLOPES
Before move on slopes, make sure the parking brake is
in good operation condition.
Do not change the direction while moving on slopes
and try to avoid moving obliquely on slopes.
When the bucket is empty, keep the bucket downward.
When the bucket is loaded, keep the bucket upward.
Keep the bucket lowed and folded.
Lower the bucket to the ground immediately in case of
emergency to help stop the machine.
When the slope is covered with wet grass or thick
leaves, it becomes extremely slippery. Do not move
the machine on this kind of slopes.
Do not move the machine on a slope with inclination
more than 15°.
If the fuel gauge indicates in red range, immediately
refuel. Inclination of machine may make the engine suck air and stop suddenly if the fuel
level is low.
2.4.3.2 MOVING ON UNUSUAL SURFACES
When moving on a slippery surface, keep low speed and avoid abrupt stops and turns.
When moving on loose ground, do not move the machine too close to the edge of cliffs
and deep ditches. It may cause overturn and fall down
of the machine.
When it is ineluctable to overpass an obstacle, make
sure that the obstacle will not incline the machine
more than 10°, keep low speed and keep the working
equipment as low as possible to the ground.
2.4.3.3 PARKING THE MACHINE
Strictly follow the instructions of parking described in
4.5
Engage the safety lock is unnecessary to keep the boom raised.
When you are going to park the machine on public road, please provide the signalling
device according to the local regulations.
WRONG

Table of Contents

Other manuals for SUNWARD SWL3210

Related product manuals