SUNWARD SWL3210 - Rear Cover Operation; Battery Information; Machine Operation Procedures; Running-In Procedure

SWL Series Skid Steer Loader
43
To close the engine hood, unlock the engine safety bar and press the cover down until the lock
engaged.
3.17 REAR COVER
Important
• The rear cover can only be opened after open the
engine hood.
To open the rear cover you must open first the engine hood.
There is a lever that allows you to open the rear cover (See
the picture below).
Lift up the lever and at the same time turns the door. Once
you have disengaged the lock turn the door to the
maximum and fix this position with the retainer. For engage
the retainer you just need to turn the restrainer and rest it to
the rear cover once you have turned the door to the maximum.
To close the rear cover disengaged the restrainer, turn the door
and press it against the chassis.
3.18 BATTERY
Complete with battery manual.
4 OPERATION OF THE MACHINE
4.1 RUNNING-IN
A new machine must be used carefully during the first 100 working hours. It is due to ensure the
proper running-in of the components. Proper running-in is important to prolong the machine life
Working with excessive load during the first operation period can cause damages to the
components.
During the running-in period (first 100 working hours), please carry out the following
indications:
• Never use machine for excessive load.
• After starting the engine, let it run with idle for 5 minutes.
• Try not operating the machine at high speed.
• Avoid abrupt starts and acceleration.
• Carry out the maintenance.
4.2 CHECKS BEFORE OPERATION
Before any operation, carry out the checking steps. If
necessary, do the repair or maintenance before work.
Before starting engine, seat properly in the operator’s seat
and keep the seat belt fasten. Check the follows:
• Application of restraint bar;
• Application of the parking brake;