SWL Series Skid Steer Loader
83
Support heavy parts prior to disassembly of the optional equipment and care about its gravity
centre during lifting the heavy parts.
Operation of suspension loading would put you and your machine into extreme danger. Promise
the safety of the loading by holding it on the supports always.
Make sure the parts are reliable and would not fall down during installation or disassembly of
any the optional equipment.
Never stand under the position of loading when it is lifted up by crane.
In case of falling down of the loading, make sure the safety by choosing proper safety position.
Operation of the crane should be carried on by skilled person. Green hand is not allowed to
operate crane.
Regarding to more detailed instruction of the optional equipment, please consult with local
agent or distributors.
6.2 SECURITY MEASURES FOR INSTALLATION
Prolonged working equipment would reduce the stability of the machine.
Be carefully when travelling on slope to avoid rolling over of the machine.
For optional equipment to be installed with the dimension beyond the standard one, pay more
attention during moving of the equipment or travelling of the machine.
6.3 PERFORMANCE OF THE OPTIONAL EQUIPMENT
Consult with local agent for choice and installation of the optional equipment.
6.4 REPLACEMENT OF OPTIONAL EQUIPMENT
Park machine on flat and stable ground. Put the optional equipment onto ground.
Before leaving machine, stop engine and move the steer handle in each direction to release
pressure and engage the safety lever.
Make sure the locking pin of quick coupler connected to the right position of the equipment
prior to operation.
Never insert your finger into the holes because accident such as cutting of the finger would be
resulted in case of there is movement unexpected or out of control.
A quick coupler is provided with the machine for connection of the bucket or other optional
equipment.
Steps for replacement of other optional equipment are identical with the ones of bucket.
Beside of the quick coupler, there are also two coupling rod and one independent hydraulic
circuit to control the optional equipment.
The optional equipment is controlled by pedal valve.
To Next Page
Loading...
