EasyManua.ls Logo

SUNWARD SWL3210 - Advice for Maintenance

SUNWARD SWL3210
89 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SWL Series Skid Steer Loader
58
Drain and change all the fluids of the machine (engine oil, engine coolant,
hydraulic oil, final transmission oil). Refill with a special anticorrosion coolant
and a special washing and protecting fuel.
Change the filters (engine fuel filter, engine oil filter, hydraulic oil filters).
Once changed all the fluids and all the filters run the machine during a while for
eliminate the residual normal fuel
Remove the battery and store with a suitable temperature and humidity. Charge
periodically the battery.
Grease all the articulation.
Close the hydraulic cylinders so that the rods remain inside the cylinder. It
prevents from the oxidation of the rod.
Seal the end of the exhaust pipe.
Block the machine by pressing the Parking brake button.
4.21.2 DURING THE PERIOD OF INACTIVITY
Start, move and operate the machine for a while once per month. Make sure to
ventilate the store before start and move the machine.
Charge the battery also once per month.
4.21.3 AFTER THE PERIOD OF INACTIVITY
After a long time of inactivity, proceed as follow:
Clean the machine deeply.
Release the exhaust pipe.
Check all the fluids level of the machine.
Install the battery and make sure it is charged.
Turn the key to position “Preheat” (See item 4.2 Starting the Machine) and check
if the entire indicators are working properly (Indicator for the fuel level, Indicator
for the oil pressure, Battery Warning Light, Preheating Light). Maintain the key
in this position until the preheating light goes out.
Start the engine and leave it at idle speed during 15 minutes.
Make sure all the function of the machine work properly.
Begin slowly to move the machine for warming up the hydraulic oil.
5 MAINTENANCE
5.1 REQUIREMENT SERVICE
The machine has been designed and manufactured for giving the maximum autonomy with a
minimum of maintenance. Before sell the machine SUNWARD has test the machine to ensure
an optimum working of the machine. To keep the machine in good working it is recommended

Table of Contents

Other manuals for SUNWARD SWL3210

Related product manuals