SWL Series Skid Steer Loader
57
Only use cable strong enough to remove the machine.
Release the parking brake before towing.
Never tow the machine for long distance.
When the machine is stuck in mud or out of order, we
need other equipments to remove the machine. Use a cable
strong enough trough the towing hook in the rear side of the
machine to remove the machine.
4.20 STARTING THE MACHINE WITH BOOSTER CABLES
Read carefully the safety regulations before perform starting the machine with booster cables.
Always follow with the safety regulations strictly.
• Make sure the voltages of the two machines are same and the aiding battery is with
greater or at least same capacity.
• Make sure the booster cables are enough for the current and with good condition.
• When connecting the cables, avoid any contact between the two terminals (+ and -).
For connecting the booster cables and starting the machine, proceed as follow:
1) Approach the two machines and get a proper distance to connect the booster
cables. But keep the two machines not touch.
2) Connect the positive terminals (+) of the two machines with one cable.
3) Connect the negative terminals (-) of the aiding battery to the earth block of
engine of the machine with the depleted battery.
4) Start the engine of the machine with the aiding battery and increase its speed.
5) Start the engine of the machine with the depleted battery.
For disconnecting the booster cables after start the machine:
1) Disconnect the connection of the negative (-) from the engine earth block and
later from the battery.
2) Disconnect the connection of positive first from the aiding battery and later
from the depleted battery.
4.21 LONG-TERM STORAGE
When store the machine, it should maximum retract the piston bar to cylinder to prevent piston
bar corrosion; clean the machine surface and all outer parts.
4.21.1 BEFORE LONG-TERM STORAGE
Before long-term storage, procedures follow must be taken:
• Choose suitable storage location: it is better to store the machine in the room, if it
only could be stored in outdoor, it must choose firm and flat ground and cover the
machine.
• Locate the machine in a sheltered place. Lower the boom and rest the bucket on
the ground.
• Clean the machine deeply.
To Next Page
Loading...
