SWL Series Skid Steer Loader
51
4.11 PARKING THE MACHINE
When you are going to park the machine, do the following
steps:
1) Try to move and park the machine on a
firm and level surface to ensure the
safety and convenience to do
maintenance.
2) Lower the working equipment to the
ground.
3) Raise the restrain bar to lock the
working equipment and traveling
system.
4) Engage the retainer for auxiliary
equipment control pedal.
5) Apply the parking brake.
6) Stop the engine.
7) Remove the ignition key from the switch
and leave the cabin.
When it is ineluctably to park the machine on slopes,
always park the machine with the bucket directed
downwards. Locate the edges under the wheels.
4.12 ACCELERATION
There are two accelerator levers in the cabin: hand accelerator and foot pedal accelerator.
The hand accelerator lever can be pulled forward and backward and fixed at any position of its
stroke. The rear end of hand accelerator stroke is the minimum limit and the front end is the
maximum limit. The revolution range goes from approximate: SWL2820: 800 rpm to 2800 rpm.
Fix the hand accelerator lever to the proper position according to the working condition.
The foot pedal accelerator is normally used to accelerate the engine temporarily. Force the pedal
with your foot to accelerate the engine. It can control the engine revolution speed from the hand
accelerator fixing speed to maximum speed.
To Next Page
Loading...
