SWL Series Skid Steer Loader
18
• Overload could cause serious injuries or even death. Never overload the machine. For
the detail capacity of machine, please refer the section of specification in this manual.
Do not try to get a better efficiency of the machine by doing any unauthorized change.
2.4.6 TRANSPORTATION
Particular care must be taken when loading and
unloading the machine.
• Try to do the loading and unloading on a firm and
level ground or a proper platform special for loading
and unloading.
• Always use ramps with adequate strength and width.
The surface of ramps must be clean. Slippery
substance on the ramp surface must be wiped up
before loading and unloading. Special treatment on the ramp surface is necessary in
rainy day. The inclination of the ramps can’t be over 15°.
• The transporting vehicle must be positioned by wedges under the wheels when
processing loading and unloading. Make sure the ramps are securely fixed on the
transporting vehicle.
• The ramps must be parallel and never do steering when traveling on the ramps. If the
machine traveling direction is not accordant with the ramps, please get down ramps and
try again.
• Always keep low speed when loading and unloading machine. Be careful that any part
more than wheels touching goods around can change your traveling trajectory.
• It is advisable to keep the bucket downward on ramps when the bucket is empty. Also
the gravity center of machine will change suddenly at the joint between ramps and
transporting vehicle, travel extremely slowly on this
point to keep the balance of machine.
2.5 MAINTENANCE PREVENTION
2.5.1 GENERAL RULES
To do any maintenance position the machine on a
firm and flat surface, rest the equipments on the
ground, engage the security locks, apply the parking
brake and stop the engine. If necessary, put wedges
under wheels to fix the machine.
Before doing the maintenance, place the warning tag
“DO NOT OPERATE” to the joysticks and ignition
switch. Make sure nobody other who is not doing
maintenance together with you operate the machine
while you doing maintenance.
Only authorized and duly trained personnel can do the
service and repair. Only do the maintenance that you are
certain. If you have any question, please consult the dealers.
Keep the machine and the ambient clean. Keep the parts and
tools in proper place.
To Next Page
Loading...
