SWL Series Skid Steer Loader
15
• Take a walk around check on the machine before work. Make sure that none component
of the machine is damaged. Repair or replace the
damaged parts if it is necessary.
• Make sure that lights are in good condition, rear-
view mirrors are clean and fix in the good position
suitable for you, windshield wipers work properly
before starting work.
• Keep the machine clean before work. Wipe up the
leakages of oil and fuel before work. It may cause
fire.
2.4.2 STARTING THE ENGINE
• Start the engine only when you are seated properly and with fastened seat belt.
• When starting the engine, engage the horn to give an alert to the persons around that you
are going to operate the machine.
• Always follow the instructions of starting engine described in the section 4.3 When it is
necessary to start the engine with booster cables, please carry out the follows. Wrong
connecting method will cause battery exploding.
1) Always wear safety goggles and rubber gloves when starting the machine with
booster cables.
2) Two persons are necessary to carry out the
starting with booster cables, one sitting in
the seat and the other one working with the
battery.
3) When starting from another machine’s
battery, do not touch the two machines. Be
sure that the normal battery voltage is same
as the problem machine battery voltage.
4) When connecting the cables, turn ignition keys of both the problem machine and
normal machine to the position of OFF.
5) The correct connecting method is parallel (positive to positive and negative to
negative).
6) Connect the positive (+) cable first when installing the booster cables. Disconnect
the negative (-) cable fist when removing them.
2.4.3 MOVING THE MACHINE
• Before move the machine, engage the horn to give an alert to the persons around.
• When moving machine, lower the boom and fold the bucket completely to get better
stability. Meanwhile it will keep enough space required by the movement.
• Keep low speed when moving on rough ground and in tough space.
Before moving backward check the area behind the machine and make sure there are no
persons or obstacles behind.
To Next Page
Loading...
