SWL Series Skid Steer Loader
69
gauge. Refill with the suitable oil if necessary.
• When refill hydraulic oil, do not exceed the
Maximum limit.
• The level must be checked with the machine in
a level surface and the oil cooled down.
• Check the hydraulic circuit when an abnormal decrease of the oil level is observed.
• Before check the level in the gauge, release the pressure inside the hydraulic tank by
loosing the filling cap.
• Before check the level in the gauge, release the pressure inside the circuit by lowering
slowly the hydraulic cylinders.
5.5.1.5 CHECKING THE ELECTRIC CABLES
• Make sure all relays and fuses are well fastened and there are not loosen cables or
connections.
• Make sure there is no sign of short circuit in the electrical system.
• Make sure there is no corroded cable or fuses. Change all the corroded cables or
fuses with same character.
5.5.1.6 CHECKING THE TIRES
• Over inflated or overheated tires could burst during operation of the machine.
• Check visually the state of the tires. Make sure there are not cracked and make
sure there are not wore out points.
• Check manually that all the nuts are tightened well.
5.5.1.7 CHECKING THE SAFETY BELT
• Check visually the screw and nuts that fasten the security belt. Make sure they are
in good condition.
5.5.1.8 CHECKING THE LEAKING OF OIL
• Check visually the hydraulic oil circuit and make sure there are no leaking in it. If any
leaks appear, repair it immediately.
• Clean the spilled oil if there is.
5.5.1.9 CHECKING THE QUICK COUPLER
• Check visually that the two coupler-pins are engaged. If any of the mechanisms is
loosen (this means one or two pins are not engaged), you and the people around
could result injured or even death.
• Never stand under the bucket, when the boom is raised.
5.5.1.10 ECKING THE WATER AND SEDIMENTS
SEPARATOR
• The fuel filter has a separator for water and sediment that it
is recommendable to drain every time you start the engine.
• The water and sediment separator is located in the engine
compartment. See the picture.
• When the ring floats on the water present in the separator, it
needs draining. Do the following procedures:
To Next Page
Loading...
