EasyManua.ls Logo

SUNWARD SWL3210 - Prevention of Damage of Working Equipment; Preventions During Operating; Machine Allowable Circumstance Condition; Safety Check before Working

SUNWARD SWL3210
89 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SWL Series Skid Steer Loader
14
• Loosen the coolant safety cap slowly when the coolant is hot to release the residual
pressure inside the tank before open it. If it is hot it may spurt out and cause serious
burns.
• Before checking the coolant level, the hydraulic oil level and the engine oil level, stop
the engine and wait till they cool down.
2.3.6 PREVENTION OF DAMAGE OF WORKING EQUIPMENT
• Do not stand in the area that the working equipment can reach when the machine is
operating. It may cause serious injury or even death.
• Before perform working equipments, the
operator must make sure that nobody is in
the dangerous area that working equipment
can reach.
• Try to lower the working equipment to the
ground every time when you park the
machine.
• During maintenance, make sure the equipment is locked correctly before go into the area
under lifted working equipment.
2.4 PREVENTIONS DURING OPERATING
Machine allowable circumstance condition
There is no need to do any adjustment when working under altitude of 2300meters。
The working temperature must be above -30 ℃,and should fully warm the machine
before starting the machine to work. The machine can be used in whole day, not only
raining or snowing, but must follow the rules of safety operation.
2.4.1 SAFETY CHECK BEFORE WORKING
2.4.1.1 CHECK THE WORKING SITE
• Before any work, do thorough check on the working site. Make sure the working site
ground conditions are available for the machine to work on.
• Make sure there is enough space for the machine to
go into the working site and come out of the
working site after the work.
• If there are water lines, gas lines, telephone lines or
electrical lines are located under the working site.
Contact the relevant companies to find out the
exact position of the lines and keep them
ineffective during whole operations.
• If you are going to work in a room on poorly
ventilated place, proper additional ventilation must be taken while working. The exhaust
of engine can be harmful to persons around.
Never use the machine in a flammable atmosphere, for example explosive vapour, gases,
or dust that may cause explosions.
2.4.1.2 CHECK THE MACHINE

Table of Contents