Supra eKey - Using Call before Showing (CBS)

Page 76 Using the eKEY Application
Tip: Press the down arrow to backspace.
10. Press 1 to select
AM or press 2 select PM.
11. Enter an hour (and minutes if applicable) in the
END time field
when prompted following the same procedure used in step 7.
Press
enter .
12. Press 1 to select
AM or press 2 select PM.
13. Insert the back of your eKEY into the KeyBox so that it fits snugly
inside the KeyBox receptacle. The gold contacts on the eKEY must
match the contacts on the KeyBox. A
Successful Operation message
appears confirming the hours the KeyBox can be accessed.
Note: If you receive an error message see Appendix A: Error Codes for
help in determining how to correct the error.
Important! The new access hours are effective immediately in the
KeyBox, however you must eSYNC before the new hours
are recorded in KIMnet.
Tip: Record the new access hours programmed in the KeyBox in
the eDATA inventory option.
Using Call Before Showing (CBS)
Each KeyBox has a Call Before Showing (CBS)code feature that allows
the listing agent to control access to a listing. When the feature is
activated in a KeyBox, the CBS code must be entered into an eKEY
before the KeyBox can be accessed. Once the showing agent enters the
CBS code into his or her eKEY, they can access the KeyBox just as they
would any other.
Activating the CBS code in a KeyBox
To activatethe CBS code in a KeyBox, youmust know the shackle code
for the KeyBox.
1. Close your eKEY shell.
2. Press the
on button.
3. Highlight the
Program Key/Keybox option.
4. Press
enter .