Page 78 Using the eKEY Application
5. Highlight the
Change CBS Code
option from the Programming sub-
menu.
6. Press
enter
.
7. When prompted, enter your four-digit shackle code for the
KeyBox. The
Program CBS
menu is displayed.
8. Press 2 to select the
Turn CBS OFF
option.
9. Insert the back of your eKEY into the KeyBox so that it fits snugly
inside the KeyBox receptacle. The gold contacts on the eKEY must
match the contacts on the KeyBox. A Successful Operation
message appears if the CBS code has been successfully de-
activated. It confirms that the CBS code is turned off in the KeyBox.
Note: If you receive an error message see Appendix A: Error Codes for
help in determining how to correct the error.
Important! The CBS code is turned off immediately in the KeyBox,
however you must eSYNC before the change is recorded
in KIMnet.
Changing a CBS code in a KeyBox
1. Close your eKEY shell.
2. Press the
on
button.
3. Highlight the
Program Key/Keybox
option.
4. Press
enter
.
To Next Page
Loading...
