Chapter 5 Page 79
5. Highlight the
Change CBS Code
option from the Programming sub-
menu.
6. Press
enter
.
7. When prompted, enter your four-digit shackle code for the
KeyBox. The
Program CBS
menu is displayed.
8. Press 3 to select the
Change CBS Code
option.
9. Enter the last four digits of the new CBS code.
Note: The KIMnet system creates a seven-digit CBS code for the
four-digit code you enter. Only you know the four-digit CBS
code used by your KeyBoxes. When other showing agents
want to access one of your listings that has the CBS code
activated, give them the seven-digit code provided by the
system.
10. Re-enter the last four digits of the new CBS code.
11. Insert the back of your eKEY into the KeyBox so that it fits snugly
inside the KeyBox receptacle. The gold contacts on the eKEY must
match the contacts on the KeyBox. A
Successful Operation
message
appears if the CBS code has been successfully changed and the new
seven-digit CBS code is displayed.
Note: If you receive an error message, verify that you are entering
the correct shackle code and repeat the procedure.
Important! The CBS code is changed immediately in the KeyBox,
however you must eSYNC before the new CBS code is
To Next Page
Loading...
