6-22 COOLING AND LUBRICATION SYSTEM
Fins bent down or dented can be repaired by straightening them
with the blade of a small screwdriver.
INSTALLATION
• Install the new gasket washers
1.
!
• Connect the oil hoses.
• Install the oil cooler.
$ Oil cooler mounting bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Tighten the oil cooler hose union bolts to the specified torque.
$ Oil cooler hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
!
Use the new gasket washers to prevent engine oil
leakage.
The oil cooler hoses should be contacted with the
stoppers
A.
PartShark.com
877-999-5686
To Next Page
Loading...
