8-40 ELECTRICAL SYSTEM
BATTERY
SPECIFICATIONS
1 Upper cover breather
5 Terminal
2 Cathode plates
6 Safety valve
3 Stopper
7 Anode plates
4 Filter
8 Separator (Fiberglass plate)
INITIAL CHARGING
Filling electrolyte
• Remove the aluminum tape
1 sealing the battery electrolyte
filler holes
A.
NOTE:
When filling electrolyte, the battery must be removed from the
vehicle and must be put on the level ground.
• Remove the caps
2.
NOTE:
* After filling the electrolyte completely, use the removed cap
2
as the sealed caps of battery-filler holes.
* Do not remove or pierce the sealed areas
3
of the electrolyte
container.
• Insert the nozzles of the electrolyte container
4 into the bat-
tery’s electrolyte filler holes, holding the container firmly so
that it does not fall. Take precaution not to allow any of the
fluid to spill.
• Make sure air bubbles
5 are coming up each electrolyte con-
tainer, and leave in this position for about more than 20 min-
utes.
Type designation YTX12 – BS
Capacity 12 V, 36.0 kC (10 Ah)/10 HR
PartShark.com
877-999-5686
To Next Page
Loading...
