Suzuki DL650K5 - Primary Driven Gear Assembly

3-70 ENGINE
CLUTCH BEARING INSPECTION
Smooth engagement and disengagement of the clutch depends
on the condition of this bearing.
Inspect the clutch release bearing for any abnormality, particu-
larly cracks, to decide whether it can be reused or should be
replaced.
CLUTCH SLEEVE HUB/PRIMARY DRIVEN GEAR ASSEM-
BLY
Inspect the slot of the clutch sleeve hub and primary driven gear
assembly for damage or wear caused by the clutch plates.
If necessary, replace it with a new one.
PRIMARY DRIVEN GEAR ASSEMBLY
DISASSEMBLY
• Remove the snap ring

1.
• Remove the oil pump drive gear

2 and pin.
INSPECTION
Inspect the primary driven gear bushing for any damage.
Inspect the spring of primary driven gear for any damages.
If necessary, replace it with a new one.
REASSEMBLY
• Install the pin

1.
• Align the oil pump drive gear slot

A with the pin

1.
PartShark.com
877-999-5686