SPARK PLUG AND PLUG CAP INSTALLATION
%
• Install the spark plugs to the cylinder heads by finger tight,
and then tighten them to the specified torque.
& Spark plug: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
NOTE:
When fitting the spark plug caps, front and rear of cylinder head
cover side, face the triangle mark A on the water-proof cover to
each cylinder exhaust side.
THROTTLE CABLE PLAY
Adjust the throttle cable play A with the following three steps.
First step:
• Loosen the lock-nut 2 of the throttle returning cable 1.
• Turn in the adjuster 3 fully.
Second step:
• Loosen the lock-nut 5 of the throttle pulling cable 4.
• Turn the adjuster 6 in or out until the throttle cable play A
should be 2.0 – 4.0 mm (0.08 – 0.16 in) at the throttle grip.
• Tighten the lock-nut 5 while holding the adjuster 6.
Third step:
• While holding the throttle grip at the fully closed position,
slowly turn out the adjuster 3 of the throttle returning cable 1
to feel resistance.
• Tighten the lock-nut 2 while holding the adjuster 3.
$ Throttle cable play A: 2.0 – 4.0 mm (0.08 – 0.16 in)
"
THROTTLE VALVE SYNCHRONIZATION
Inspect the throttle valve synchronization periodically. (!Page 61)
Before using a spark plug wrench, carefully turn the
spark plug by finger into the threads of the cylinder
head to prevent damage the aluminum threads.
Inspect initially at 1 000 km (600 miles, 2 month) and
every 6 000 km (4 000 miles, 12 months) thereafter.
After the adjustment is completed, check that handle-
bar movement does not raise the engine idle speed
and that the throttle grip returns smoothly and auto-
matically.
Inspect initially at 1 000 km (600 miles, 2 months) (E-33
only) and every 12 000 km (7 500 miles, 24 months).
13-14 DL650K7/AK7 (’07-MODEL)
PartShark.com
877-999-5686
To Next Page
Loading...
