Suzuki DL650K5 - Engine Top Side

3-94 ENGINE
STARTER MOTOR
• Install the new O-ring to the starter motor.
#
• Apply SUZUKI SUPER GREASE to the O-ring.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the starter motor

1.
• Tighten the starter motor mounting bolts with the clamp

2
securely.
NOTE:
First tighten the starter motor mounting bolt

A
.
ENGINE TOP SIDE
PISTON
• Install the piston rings in the order of oil ring, 2nd ring and 1st
ring.
• The first member to go into the oil ring groove is a spacer

1.
After placing the spacer, fit the two side rails

2.
NOTE:
Side designations, top and bottom, are not applied to the spacer
and side rails: you can position each either way.
#

A INCORRECT

B CORRECT
• Install the 2nd ring

3 and 1st ring

4.
NOTE:
1st ring and 2nd ring differ in shape.
Use the new O-ring to prevent oil leakage.
When installing the spacer, be careful not to allow its
two ends to overlap in the groove.
PartShark.com
877-999-5686