ENGINE 3-93
• Install the clutch cover.
GENERATOR COVER
• Apply MOLYBDENUM OIL SOLUTION to both ends of the
shaft
1.
* MOLYBDENUM OIL SOLUTION
• Install the starter idle gear
2 and shaft
1.
• Install the dowel pins
3 and gasket
4.
#
• Install the generator cover.
$ Generator cover bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
Fit the gasket washers to the generator cover bolts
A
correctly
as shown.
#
OIL FILTER
• Install the oil filter with the special tool. (!2-13)
" 09915-40610: Oil filter wrench
Use the new gasket to prevent oil leakage.
Use the new gasket washers to prevent oil leakage.
PartShark.com
877-999-5686
To Next Page
Loading...
