3-92 ENGINE
• Install the clutch push rod
B into the countershaft.
• Install the clutch push piece
C, the bearing
D and thrust
washer
E to the countershaft.
NOTE:
Thrust washer
E
is located between the pressure plate and
bearing
D
.
• Hold the generator rotor (crankshaft) with the special tool.
" 09930-44530: Rotor holder
• Install the clutch pressure plate.
• Tighten the clutch spring set bolts to the specified torque.
$ Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
Tighten the clutch spring set bolts diagonally.
CLUTCH COVER
• Install the gasket
1 and dowel pins
2.
#
Use the new gasket to prevent oil leakage.
PartShark.com
877-999-5686
To Next Page
Loading...
